Journal article 1407 views
Effect of spray-drying and cryo-milling on the CO2absorption performance of C60cross-linked polyethyleneimine
,
Andrew Barron
Journal of Materials Chemistry A, Volume: 3, Issue: 8, Pages: 4323 - 4329
Swansea University Authors:
Enrico Andreoli , Andrew Barron
Full text not available from this repository: check for access using links below.
DOI (Published version): 10.1039/C4TA06936F
Abstract
The high CO2 capacity of PEI-C60 conjugates is impeded by a slow rate of absorption. A limiting factor to this rate is proposed to be the surface area available for the rapid contact between amine functional groups of PEI and CO2. Increasing the surface area by spray-drying a solution of reagents is...
| Published in: | Journal of Materials Chemistry A |
|---|---|
| ISSN: | 2050-7488 2050-7496 |
| Published: |
2015
|
| Online Access: |
Check full text
|
| URI: | https://cronfa.swan.ac.uk/Record/cronfa21053 |
| Tags: |
Add Tag
No Tags, Be the first to tag this record!
|
| Abstract: |
The high CO2 capacity of PEI-C60 conjugates is impeded by a slow rate of absorption. A limiting factor to this rate is proposed to be the surface area available for the rapid contact between amine functional groups of PEI and CO2. Increasing the surface area by spray-drying a solution of reagents is proposed as a route to larger surface area products. In this work we investigate process changes to control absorption chemistry. Reagent solutions were spray-dried in different experimental conditions of concentration, drying temperature, and feed pressure. The results indicate that the rate of CO2 absorption at room temperature can be improved by a factor of 2.5 times by spray drying the product when compared to the product obtained using sonication. Given the rubbery nature of PEI-C60 the surface area, and hence CO2 capacity, could be increased using cryogenic grinding in liquid nitrogen; however, the results show that this has limited effect on the surface area of the absorbent prepared using sonication. Only compared to the hard chunks obtained via stir bar synthesis was the surface area doubled, in contrast to the rubbery product obtained using ultrasonication the area did not change significantly. Interestingly, doubling the surface area, the rate of absorption of wet CO2 at high temperature did not change, while that at low temperature doubled in rate, consistent with the presence of diffusion limitations manly at low temperature. |
|---|---|
| College: |
Faculty of Science and Engineering |
| Issue: |
8 |
| Start Page: |
4323 |
| End Page: |
4329 |