E-Thesis 281 views 554 downloads
Nonlinear finite element simulation of non-local tension softening for high strength steel material. / F. M Tong
Swansea University Author: F. M Tong
-
PDF | E-Thesis
Download (6.97MB)
Abstract
The capability of current finite element softwares in simulating the stress-strain relation beyond the elastic-plastic region has been limited by the inability for non- positivity in the computational finite elements' stiffness matrixes. Although analysis up to the peak stress has been proved a...
| Published: |
2008
|
|---|---|
| Institution: | Swansea University |
| Degree level: | Master of Philosophy |
| Degree name: | M.Phil |
| URI: | https://cronfa.swan.ac.uk/Record/cronfa42368 |
| Abstract: |
The capability of current finite element softwares in simulating the stress-strain relation beyond the elastic-plastic region has been limited by the inability for non- positivity in the computational finite elements' stiffness matrixes. Although analysis up to the peak stress has been proved adequate for analysis and design, it provides no indication of the possible failure predicament that is to follow. Therefore an attempt was made to develop a modelling technique capable of capturing the complete stress-deformation response in an analysis beyond the limit point. This proposed model characterizes a cyclic loading and unloading procedure, as observed in a typical laboratory uniaxial cyclic test, along with a series of material properties updates. The Voce equation and a polynomial function were proposed to define the monotonic elastoplastic hardening and softening behaviour respectively. A modified form of the Voce equation was used to capture the reloading response in the softening region. To accommodate the reduced load capacity of the material at each subsequent softening point, an optimization macro was written to control this optimum load at which the material could withstand. This preliminary study has ignored geometrical effect and is thus incapable of capturing the localized necking phenomenon that accompanies many ductile materials. The current softening model is sufficient if a global measure is considered. Several validation cases were performed to investigate the feasibility of the modelling technique and the results have been proved satisfactory. The ANSYS finite element software is used as the platform at which the modelling technique operates. |
|---|---|
| Keywords: |
Materials science. |
| College: |
Faculty of Science and Engineering |