No Cover Image

Journal article 842 views 214 downloads

Using Soft Polymer Template Engineering of Mesoporous TiO2 Scaffolds to Increase Perovskite Grain Size and Solar Cell Efficiency

Qing Lian, Muhamad Z. Mokhtar, Dongdong Lu, Mingning Zhu, Janet Jacobs, Andrew B. Foster, Andrew G. Thomas, Ben F. Spencer, Shanglin Wu, Chen Liu, Nigel W. Hodson, Benjamin Smith, Abdulaziz Alkaltham, Osama M. Alkhudhari, Trystan Watson Orcid Logo, Brian R. Saunders

ACS Applied Materials & Interfaces, Volume: 12, Issue: 16, Pages: 18578 - 18589

Swansea University Author: Trystan Watson Orcid Logo

  • 54160.pdf

    PDF | Version of Record

    This is an open access article published under a Creative Commons Attribution License (CC-BY).

    Download (6.4MB)

Check full text

DOI (Published version): 10.1021/acsami.0c02248

Abstract

The mesoporous (meso)-TiO2 layer is a key component of high-efficiency perovskite solar cells (PSCs). Herein, pore size controllable meso-TiO2 layers are prepared using spin coating of commercial TiO2 nanoparticle (NP) paste with added soft polymer templates (SPT) followed by removal of the SPT at 5...

Full description

Published in: ACS Applied Materials & Interfaces
ISSN: 1944-8244 1944-8252
Published: American Chemical Society (ACS) 2020
Online Access: Check full text

URI: https://cronfa.swan.ac.uk/Record/cronfa54160
Tags: Add Tag
No Tags, Be the first to tag this record!
Abstract: The mesoporous (meso)-TiO2 layer is a key component of high-efficiency perovskite solar cells (PSCs). Herein, pore size controllable meso-TiO2 layers are prepared using spin coating of commercial TiO2 nanoparticle (NP) paste with added soft polymer templates (SPT) followed by removal of the SPT at 500 °C. The SPTs consist of swollen crosslinked polymer colloids (microgels, MGs) or a commercial linear polymer (denoted as LIN). The MGs and LIN were comprised of the same polymer, which was poly(N-isopropylacrylamide) (PNIPAm). Large (L-MG) and small (S-MG) MG SPTs were employed to study the effect of the template size. The SPT approach enabled pore size engineering in one deposition step. The SPT/TiO2 nanoparticle films had pore sizes > 100 nm, whereas the average pore size was 37 nm for the control meso-TiO2 scaffold. The largest pore sizes were obtained using L-MG. SPT engineering increased the perovskite grain size in the same order as the SPT sizes: LIN < S-MG < L-MG and these grain sizes were larger than those obtained using the control. The power conversion efficiencies (PCEs) of the SPT/TiO2 devices were ∼20% higher than that for the control meso-TiO2 device and the PCE of the champion S-MG device was 18.8%. The PCE improvement is due to the increased grain size and more effective light harvesting of the SPT devices. The increased grain size was also responsible for the improved stability of the SPT/TiO2 devices. The SPT method used here is simple, scalable, and versatile and should also apply to other PSCs.
Keywords: perovskite solar cells, template engineering, mesoporous TiO2, microgel, porosity, grain size
Issue: 16
Start Page: 18578
End Page: 18589