Journal article 193 views 50 downloads
Indentation Plastometry of Welds
Advanced Engineering Materials, Volume: 24, Issue: 9, Start page: 2101645
PDF | Version of Record
This is an open access article under the terms of the Creative Commons Attribution LicenseDownload (6.16MB)
This investigation concerns the application of the profilometry‐based indentation plastometry (PIP) methodology to obtain stress–strain relationships for material in the vicinity of fusion welds. These are produced by The Welding Institute (TWI), using submerged arc welding to join pairs of thick st...
|Published in:||Advanced Engineering Materials|
Check full text
No Tags, Be the first to tag this record!
This investigation concerns the application of the profilometry‐based indentation plastometry (PIP) methodology to obtain stress–strain relationships for material in the vicinity of fusion welds. These are produced by The Welding Institute (TWI), using submerged arc welding to join pairs of thick steel plates. The width of the welds varies from about 5 mm at the bottom to about 40–50 mm at the top. For one weld, the properties of parent and weld metal are similar, while for the other, the weld metal is significantly harder than the parent. Both weldments are shown to be approximately isotropic in terms of mechanical response, while there is a small degree of anisotropy in the parent metal (with the through‐thickness direction being slightly softer than the in‐plane directions). The PIP procedure has a high sensitivity for detecting such anisotropy. It is also shown that there is excellent agreement between stress–strain curves obtained using PIP and via conventional uniaxial testing (tensile and compressive). Finally, the PIP methodology is used to explore properties in the transition regime between weld and parent, with a lateral resolution of the order of 1–2 mm. This reveals variations on a scale that would be very difficult to examine using conventional testing.
indentation plastometry, inverse finite element method (FEM), welds
Faculty of Science and Engineering
Engineering and Physical Sciences Research Council Grant: EP/I038691/1 Grant: EP/M028267/1 Grant: EM/2019-038/4 Grant: IN-2016-004 Grant: ST/R006105/1