Journal article 504 views 110 downloads
Approaches to fatigue lifing in a high strength polycrystalline nickel alloy
International Journal of Fatigue, Volume: 166, Start page: 107239
Swansea University Authors:
Mark Whittaker , Nick Barnard, Ben Cockings, Emily Duffy
-
PDF | Version of Record
© 2022 The Authors. This is an open access article under the CC BY license
Download (4.7MB)
DOI (Published version): 10.1016/j.ijfatigue.2022.107239
Abstract
The development of high strength alloys with complex chemistries has led to modern nickel disc alloys being produced through a powder metallurgy process which often produces melt anomalies within the material microstructure. The current research investigates the effect of these melt anomalies on ove...
Published in: | International Journal of Fatigue |
---|---|
ISSN: | 0142-1123 |
Published: |
Elsevier BV
2023
|
Online Access: |
Check full text
|
URI: | https://cronfa.swan.ac.uk/Record/cronfa61165 |
Tags: |
Add Tag
No Tags, Be the first to tag this record!
|
Abstract: |
The development of high strength alloys with complex chemistries has led to modern nickel disc alloys being produced through a powder metallurgy process which often produces melt anomalies within the material microstructure. The current research investigates the effect of these melt anomalies on overall lifing approaches for the alloy RR1000, utilised here in its fine grained form. A Walker strain approach is applied to investigate the effect of temperature and R ratio on lifing parameters, and a temperature dependent version of the equation is suggested and used to produce predictions of notched specimen fatigue behaviour. It is found that hard particle inclusions dominate fatigue failures at long fatigue lives whereas failure occurred at the peened surface for shorter fatigue lives. However, lifing approaches were able to provide good fits across the entire data set irrespective of this behaviour change. |
---|---|
Keywords: |
Fatigue; Melt anomaly; Notches; Walker strain |
College: |
Faculty of Science and Engineering |
Funders: |
This work was supported by the UK Technology Strategy Board (SILOET II Project 6 - High Temperature Capability – Compressors and Discs, TP110120). A PhD stipend for Emily Duffy under the EPSRC Rolls-Royce Strategic Partnership in Structural Metallic Systems for Gas Turbines (grants EP/H500383/1 and EP/H022309/1) is also gratefully acknowledged along with funding from Rolls-Royce plc. The input of Dr Mark Evans is also gratefully acknowledged. |
Start Page: |
107239 |