Journal article 141 views 22 downloads
Environmental Analysis of Integrating Photovoltaics and Energy Storage in Building
Procedia CIRP, Volume: 105, Pages: 613 - 618
Swansea University Authors: Guangling Zhao, Justin Searle , Joanna Clarke, Jenny Baker
PDF | Version of Record
Distributed under the terms of a Creative Commons CC-BY-NC-ND license.Download (684.74KB)
DOI (Published version): 10.1016/j.procir.2022.02.102
The energy consumption of buildings accounts for approximately 36 % of the final energy consumption in Europe, being the largest end-user. The UK government has committed to cut greenhouse gas (GHG) emissions by 100 % below 1990 levels and bring all GHG emissions to net-zero by 2050.To support the r...
|Published in:||Procedia CIRP|
Check full text
No Tags, Be the first to tag this record!
The energy consumption of buildings accounts for approximately 36 % of the final energy consumption in Europe, being the largest end-user. The UK government has committed to cut greenhouse gas (GHG) emissions by 100 % below 1990 levels and bring all GHG emissions to net-zero by 2050.To support the realisation of these goals the concept of an Active Building was formulated which refers to any building type, such as factories, offices, homes, and other structures in the built environment, which are equipped to conserve, generate, store, and release energy. The increasing deployment of rooftop photovoltaics drives the growth of energy storage to capture solar energy for later use in buildings. The Active Office was built at Swansea University, UK in 2018 and is a two-story office building. Its energy demand, including that of electric vehicle charging, is primarily met by the 23 kWp of building-integrated photovoltaics (BIPV) and 110 kW of lithium-ion (Li-ion) batteries. When the BIPV and batteries are unable to meet the demand, electricity supplied from the grid can be used.The objective of the research is to assess the potential environmental impacts of the building energy system of BIPV and Li-ion batteries, as well as to address the lifetime and degradation of Li-ion batteries, and the associated consequences. Life cycle assessment (LCA) is employed in this research. Three operational strategies are designed regarding the interactions between the electrical grid, BIPV, and Li-ion batteries. In the best case operational scenario, using a rolling average to predict building generation and consumption, the GWP from the building operation is 33 g/kWh which is a 5 fold reduction compared with the grid emissions of 170 g/kWh. The worst case building operational strategy creates emissions of 128 g/kWh, it is still an improvement upon electricity supply by the national grid alone. This analysis demonstrates that operational strategy optimisation can reduce the environmental impacts of the Active Building concept compared with using grid electricity alone.
The 29th CIRP Conference on Life Cycle Engineering, April 4 – 6, 2022, Leuven, Belgium. Edited by Wim Dewulf, Joost Duflou.
Photovoltaics, Battery Energy storage, Life Cycle Assessment, Battery Operation
Faculty of Science and Engineering
This work was supported by the Engineering and Physical Sciences Research Council (EPSRC) through ECR Fellowship NoRESt (EP/S03711X/1) and SPECIFIC Innovation and Knowledge Centre (EP/N020863/1 and EP/P030831/1). Matt Roberts was supported by a Leveraged University Research
Studentship, provided by the University of Bath. Dr. Stephen Allen was supported by the “The Active Building Centre Research Programme” [EP/V012053/1].